Mercury 50 4-Stroke - Inspection and Maintenance Schedule

OPERATION
56
1. Open fuel tank vent screw (in filler cap) on manual venting type
fuel tanks.
19748
2. Connect the remote fuel line to the outboard. Make sure the
connector is snapped into place.
28526
3. Position the fuel line primer bulb so the arrow on the side of
the bulb is pointing up. Squeeze the fuel line primer bulb
several times until it feels firm.
27348
4. Set the lanyard stop switch to "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791