Model 700A User's Manual Configuring Your System
Information in this document is subject to change without notice!!! Page 11-11
If your system is running on APM (Advanced Power Management) mode, you can
switch between these 4 Power Saving Levels by pressing <Fn><F7>. The advantage of
using <Fn><F7> is that you do not have to go through the trouble of entering the SETUP
to switch between these levels. And <Fn><F7> is a cyclical switch that allows you to
loop back to your original setting by pressing <Fn><F7> repeatedly. You would hear the
following beeps when you enter the levels below:
Power Saving Levels Beep Descriptions
Off 1 beep
Custom 2 beeps
High Perform 3 beeps
Longest Life 4 beeps
For more information on APM and ACPI modes, please refer to Chapter 6.7.
CPU Speed Control:
You would be able to set this field only when the Power Saving Level is set to Custom.
There are four options to this field: 100%, 50%, 25%, 12.5%. Select the one that
provides you the maximum power rationing while without entailing any noticeable
degradation of performance.
Hard Disk Time-out:
You would be able to set this field only when the Power Saving Level is set to Custom.
Select the time duration of which the hard disk would idle before spinning down. The
amount of time for the hard disk to spin-up to its normal operating speed depends on its
manufacturer and is around 3~5 seconds. If you are a performance-conscious user, you
may like to set this field to Off.
Video Time-out:
You would be able to set this field only when the Power Saving Level is set to Custom.
Select the time duration of which both the keyboard and mouse have no activity before
turning off the LCD display. Any activities from keyboard or mouse would turn on the
display immediately.
Standby Time-out:
You would be able to set this field only when the Power Saving Level is set to Custom.
Select the time duration of which the system has no activity before entering Standby. In
To Next Page
Loading...