Configuring Your System Model 700A User's Manual
Page 11-12 Information in this document is subject to change without notice!!!
Standby mode, the LCD display would be turned off. Any activities from keyboard or
mouse would resume the system to its normal operation immediately.
Auto Suspend Time-out:
You would be able to set this field only when the Power Saving Level is set to Custom.
Select the time duration of which the system has no activity before entering the type of
suspend mode, as determined by the setting in Suspend Option below. Suspend Option
has two option: Suspend (also referred to as STR) and, STF.
LCD Suspend:
There are two options to this field: Disabled, and Enabled. If this field is set to Enabled,
system would enter the type of suspend mode (as determined by the setting in Suspend
Option), when the LCD display is closed. Suspend Option has two option: Suspend
(also referred to as STR) and, STF.
Suspend Option:
There are two options to this field: Suspend, and STF. Suspend can also be referred to as
Suspend-To-RAM (STR). STF stands for Suspend-To-File, and can also be referred to
as hibernate/hibernation. STF provides as much as a power saving as if the system had
been powered off. While STR provides less power saving than STF, STR saves more
power than when the system is in Standby mode. The way to trigger a resumption from
STR and STF are the same; by pressing the Power Switch. However resuming from STF
takes a significantly more time than resuming from STR.
Auto Save To File:
There are two options to this field: Disabled, and Enabled. With this field set to
Enabled, system would automatically enter Save-To-File (STF) mode after the system
has been in Suspend-To-RAM (STR) mode continuously for 30 minutes.
Panel Brightness:
There are two options to this field: Auto, and User Defined. You can manually adjust the
brightness of the display panel by using the hot-keys: <Fn><F8>, and <Fn><F9>. With
this field set to Auto, system would automatically lower its display brightness if there is
not keyboard and mouse activity for 15 seconds. The display would resume to its user-
manually selected brightness immediately after you invoke any keyboard or mouse
activities.
To Next Page
Loading...