Model 700A User's Manual Configuring Your System
Information in this document is subject to change without notice!!! Page 11-13
Suspend Warning Tone:
There are two options to this field: Enabled, and Disabled. In general, you should enable
the Suspend Warning Tone that beeps before the system enters the type of suspend
designated by Suspend Option.
Remote Power On:
There are two options to this field: Enabled, and Disabled. If Enabled, system would
resume from STR or STF, whenever there is any incoming call from the serial
fax/modem, or request from LAN card.
Wake Up Alarm/ Resume Alarm Time:
Wake Up Alarm and Resume Alarm Time work hand-in-hand with one another. There
are two options to Wake Up Alarm: Disabled, and Enabled. You would be able to set
the Resume Alarm Time only if Wake Up Alarm has been set to Enabled. For example
with these two fields set to Enabled and 8:00AM respectively, the system would be able
to wake (resume) itself from Suspend (also referred to as STR) or STF to normal
operation at 8:00AM. The amount of time required to wake up from STF is somewhat
longer than STR.
Note: The time-out settings in the Power Management Setup is not applicable to
ACPI OS’s: Win98 ACPI and Win 2000.
To Next Page
Loading...