EasyManuals Logo
Home>Mercury>Boating Equipment>Axius System

Mercury Axius System User Manual

Mercury Axius System
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #49 background imageLoading...
Page #49 background image
Section 3 - Troubleshooting
CMD-4082082 / 90-8M0052072 eng FEBRUARY 2011 Page 45
Electronic Remote Controls
Symptom Remedy
The ERC (electronic remote control) lever is too hard or too
easy to move out of neutral detent.
Adjust detent tension. See Section 1.
The ERC lever has too much or too little resistance through
its range of motion.
Adjust the handle tension screw. See Section 1.
The ERC lever increases engine RPM, but the engines do not
engage gears and the boat does not move.
Turn the key switch to off and back to on.
Check the "Throttle Only" button on the DTS trackpad. Put the
ERC levers in neutral and push the button to disengage, if the
light is on.
Engage gears manually. See Section 2, Axius Shift Override
—Emergency Procedure.
Contact your Authorized CMD Repair Facility.
The ERC lever controls the engine and drive, but does not
reach wide open throttle.
If the engine only reaches 50% of WOT, check the "DOCKING"
button on the DTS trackpad. Put the handles in neutral and push
the button to disengage, if light is on.
Check VesselView to see if cruise control is enabled. Disable
cruise control.
Check for damage to the propeller. If found, contact your
Authorized CMD Repair Facility service technician to ask if the
propellers need to be repaired or changed.
Check VesselView for Guardian fault codes that indicate reduced
engine power. If found, contact your Authorized CMD Repair
Facility.
The ERC lever controls the engine and drive, but does not
respond in a linear manner.
Check whether dock mode or cruise control are on. If on, turn off
or disengage.
When one ERC lever is moved, both engines respond.
Check the "1 LEVER" button on the DTS track pad. If the light is
on, put the handles in neutral and push the "1 LEVER" button to
disengage.
The ERC control, stop‑start buttons, joystick, and steering
wheel do not function.
Press "TRANSFER" on DTS track pad to restore helm control.
(Multiple helm boats only.)
Boat goes forward but will not go backwards quickly. Trim drives down.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury Axius System and is the answer not in the manual?

Mercury Axius System Specifications

General IconGeneral
BrandMercury
ModelAxius System
CategoryBoating Equipment
LanguageEnglish

Related product manuals