D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 28 of 90
Checking Transom Thickness
Ensure transom surface thickness and flatness conform to minimums specified in “Installa-
tion Requirements” listed previously.
NOTE: Transom must be between 2” (51 mm) and 2-1/4” (57 mm) a distance of 8” (203 mm)
to either side of the vertical centerline.
a
b
c
a-Measuring Thickness
b-Measuring Flatness
c-Suitable Mandrel To Check For Uniform Transom Thickness.
To Next Page
Loading...
