D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 62 of 90
Sterndrive Unit Installation
1. Remove trim cylinders’ support and dust cover from bell housing studs. Retain locknuts
and flat washers.
2. Remove cap and fill gear lube monitor.
75955
a
b
a-Gear Lube Monitor
b-Cap
3. Push in on dribble valve until gear lube appears.
72471
a
a-Dribble Valve
4. Once gear lube appears, release dribble valve.
5. Fill monitor to FILL mark.
6. Replace monitor cap.
To Next Page
Loading...
