D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 38 of 90
SEAWATER HOSE
NOTE: The trim limit switch wires and speedometer hose are attached to the water hose.
Prior to cutting the hose, move the wires and speedometer hose to avoid cutting them when
cutting water hose. The existing sta-strap and clip can be reused if they are moved out of
the way while cutting the water hose.
1. Move existing sta-strap and clip. Cut the water hose in the area shown. Loosen clamp
and remove short piece of hose remaining on gimbal housing.
2. Secure the trim limit switch wires and speedometer hose to remaining hose piece on
transom assembly.
75852
71184
a
b
d
f
c
e
g
a-Sta-Strap
b-Clip
c-Seawater Inlet Hose
d-Speedometer Hose
e-Trim Limit Wire Harness
f-Cut Water Hose Here
g-Hose Piece – To Be Removed
To Next Page
Loading...
