4 - OPERATION
90-8M0098854 MARCH 2015 29
1
2
3
4
5
6
7
8
9
ELECTRICAL PANEL COMPONENT IDENTIFICATION
If an electrical overload occurs, a fuse or circuit breaker opens.
Locate and correct the problem before replacing the fuse or
resetting the circuit breaker.
One circuit breaker protects the engine wiring harness and one
circuit breaker protects the fuel pump circuit. Reset by pushing the
reset button.
a - Starboard fuse holder
b - Forward shift relay
c - Main power circuit breaker
d - Diagnostic connection
e - Fuel pump circuit breaker
f - Reverse shift relay
g - PCM 09
h - 14 Pin connector
i - Hot stud with two 110 amp fuses
j - Negative stud
k - Diagnostic fuse
l - Connector A
a
b
c
d
e
f
g
h
i
j
k
l
mn
o
p
q
r
s
t
u
45775
m - Connector B
n - Connector C
o - Main power relays
p - Start relay
q - Accessory fuses
r - Trim pump down relay
s - Trim pump up relay
t - Fuel pump relays
u - Port fuse holder
Starboard Fuse
Holder ‑ a
Port Fuse Holder ‑
u Accessory Fuses ‑ q
(1)—Cyl. 6 coil
and fuel injector
(1)—Cyl. 5 coil
and fuel injector
(1)—Wastegate actuators
(2)—Cyl. 2 coil
and fuel injector
(2)—Cyl. 1 coil
and fuel injector
(2)—Main power relays and
diagnostic fuse feed
(3)—Cyl. 8 coil
and fuel injector
(3)—Cyl. 7 coil
and fuel injector
(3)—Shift relays
(4)—Cyl. 4 coil
and fuel injector
(4)—Cyl. 3 coil
and fuel injector
(4)—(+) 12 volt power
REMOTE CONTROLS (CONSOLE MOUNTED ZERO EFFORT)
1. Shift only with the engine at idle speed. Always move to the
desired gear position with a quick, firm motion.
To Next Page
Loading...
