Mercury Racing 1100 STERNDRIVE - Changing Drive Unit Oil (Dry Sump)

6 - MAINTENANCE
90-8M0098854 MARCH 2015 49
1
2
3
4
5
6
7
8
9
2. Remove the drain plug and the filter.
a - Filter
b - Drain plug
3. Install the transmission drain plug.
4. Apply clean transmission fluid to the seal on the filter and
tighten it one turn beyond the contact point.
5. Fill the transmission through the dipstick tube with three
quarts of Type F
1.
or FA transmission fluid.
6. Start the engine and let it run for at least two minutes at 1500
RPM, shifting the transmission from forward to reverse
several times.
7. Stop the engine and check the transmission oil level with the
dipstick. If additional oil is required, add it in 200 cc (½ pint)
increments through the dipstick tube to bring the level up to
the "FULL" mark.
a
b
45708
a -
Dipstick
b - "FULL" mark
c - Dipstick tube
CHANGING DRIVE UNIT OIL (DRY SUMP)
DRIVELINE MODELS ONLY
1. Place a container below the input shaft housing and remove
the bottom pipe plug.
a - Input shaft housing
b - Oil drain pipe plug
IMPORTANT: Do not overfill the input shaft housing reservoir or
damage to the transom components could occur.
a
b
FULL
c
6790
b
a
7445
1. Use type FA only if type F is not available