4 - OPERATION
90-8M0098854 MARCH 2015 31
1
2
3
4
5
6
7
8
9
4. Check the coolant temperature gauge to ensure that the
engine temperature is not abnormally high. If it is, stop the
engine immediately and determine the cause.
5. Ensure that the charging system is functioning correctly.
6. Observe the power package for fuel, oil, water, and exhaust
leaks.
OPERATION CHART
1.
Before Starting
Open the engine hatch.
Turn battery switch "ON," if equipped.
Operate bilge blowers, if equipped.
Open fuel shut off valve.
Open seacock, if equipped.
Perform all other checks specified by your dealer and/or
boat builder.
2.
After Starting
Observe all gauges to check condition of engine. If not
normal, stop engine.
Check for fuel, oil, water, fluid and exhaust leaks, etc.
Check shift and throttle control operation.
Check steering operation.
3.
While Underway
Observe all gauges to monitor engine condition.
4.
After Stopping
Shift to neutral. Turn ignition key "OFF."
Turn battery switch "OFF," if equipped.
Close fuel valve.
Close seacock.
Flush cooling system if in saltwater area.
FREEZING TEMPERATURE OPERATION
IMPORTANT: If boat is operated in freezing temperatures, ensure
that closed coolant is rated for the temperature range in which it is to
be used. The seawater section of the engine must be drained after
use to prevent freezing. Damage caused by freezing is not covered
by Mercury Racing's Limited Warranty.
DRAIN PLUG AND BILGE PUMP
The engine compartment in your boat is a natural place for water to
collect. For this reason, boats are normally equipped with a drain
plug and/or a bilge pump. It is very important to check these items
on a regular basis to ensure that the water level does not rise to
come in contact with your power package. Engine components will
be damaged if submerged. Damage caused by submersion is not
covered by the Mercury Racing Limited Warranty.
To Next Page
Loading...
