6 - MAINTENANCE
90-8M0098854 MARCH 2015 55
1
2
3
4
5
6
7
8
9
NOTE: Do not paint anodes or the MerCathode system reference
electrode and anode, as this will render them ineffective as
galvanic corrosion inhibitors.
2.
Painting Drive Unit or Transom Assembly
• Paint the drive unit and transom assembly with a good
quality marine paint or an anti‑fouling paint that does not
contain copper, tin, or any other material that could
conduct electrical current. Do not paint drain holes,
anodes, or items specified by the boat manufacturer.
3.
Additional Corrosion Prevention Tips
• Spray the power package components on the inside of the
boat every two to three weeks to protect the finish from
dulling and corrosion. External power package
components may also be sprayed.
Tube
Ref No.
Description Where Used Part No.
120
Corrosion
Guard
Power package 92-802878 55
• All lubrication points, especially the steering system and
shift and throttle linkages, should be kept well lubricated.
• Flush the cooling system after each use.
BOTTOM OF BOAT
To maintain maximum speed, ensure that the boat bottom is:
• Clean, free of barnacles and marine growth.
• Free of distortion, nearly flat where it contacts water.
• Straight and smooth, fore and aft.
ANTI‑FOULING PAINTS
See anti‑fouling paint recommendations and related information on
previous pages.
IMPORTANT: Refer to
Corrosion and Corrosion Protection
for
additional information.
INSPECTION AND MAINTENANCE
Inspect the power package often and at regular intervals to help
maintain its top operating performance, and correct potential
problems before they occur. The entire power package should be
checked carefully, including all accessible engine parts.
1. Check for loose, damaged or missing parts, hoses and
clamps; tighten or replace as required.
2. Check plug leads and electrical leads for damage.
3. Remove and inspect the propeller. If nicked, bent or cracked,
see your authorized Mercury Marine dealer.
4. Repair nicks and corrosion damage on the power package's
exterior finish.
ATTENTION REQUIRED AFTER SUBMERSION
• Before recovery, contact an authorized Mercury Marine
dealer.
• After recovery, immediate service by an authorized Mercury
Marine dealer is required to prevent serious damage to power
package.
To Next Page
Loading...
