Merida CENTURION - Page 104

104
Component Shimano
1
(Nm) Avid
2
(Nm) Tektro
3
(Nm) TRP
4
(Nm) Magura HS
5
(Nm)
Bleeding device brake lever 2 - 4
Brake disc fixing (6-holes) 4 6.2 4 - 6 6 - 8
Brake disc fixing (Centerlock) 40
Hose (union nut) direct connection 4
Slave cylinder (bleeder screw) 4
Brake pad retainer at brake caliper 3 - 5
Cable clamp at brake caliper 4 - 6
1
www. shimano.com
2
www.sram.com
3
www.tektro.com
4
www.trpbrakes.com
5
www.magura.com
These values are reference values of the above-mentioned component manufacturers. Observe the values in the instructions of the component
manufacturers on this CENTURION CD-ROM. These values do not apply to the components of other manufacturers.
I
Due to the unmanageable number of components on the market, CENTURION is not in a position to foresee every product that
will be replaced or newly assembled by third parties. Therefore CENTURION denies any liability for such kind of additions or
modifications with regard to compatibility, torque values etc. Whoever assembles or modifies the CENTURION bike shall ensure
that the bike was assembled according to the state-of-the-art in science and technology.
I
Some components have the maximum permissible torque values printed on them. Use a torque wrench and never exceed the
maximum torque value! If you are in doubt or if you have any questions, contact your CENTURION dealer.
i
For more information on components not listed in these tables, see the instructions of the component manufacturers on this
CENTURION CD-ROM.