5
2.3.2 To replace the anti-tip wheel [See Illus. 05]
◆ When to replace the anti-tip wheel?
◇ The anti-tip wheel is worn out.
◇ The scooter can not avoid bumping because of the anti-tip wheel.
◆ How to replace the anti-tipper assembly?
◇ Please proceeding following steps.
1. Use hex. tools and wrench to loosen the screw (4.31) and nut
(4.33).
2. Remove/replace the anti-tip wheel (4.30).
2.3.3 To replace the driven wheel assembly [See Illus. 06]
◆ When to replace the driven wheel assembly?
◇ The driven wheel assembly is deformaed, worn out, or pierced.
◆ How to replace the driven wheel assembly?
◇ Please proceeding following steps.
1. Remove the hub cap (4.72).
2. Loosen the nut (4.74) and washer (4.73).
3. Remove/replace the driven wheel (4.71).
2.3.4 To replace the transaxle assembly [See Illus. 07]
◆ When to replace the transaxle assembly?
◇ There is noise on transaxle assembly.
◇ The transaxle assembly is not working properly.
◆ How to replace the transaxle assembly?
◇ Please proceeding following steps.
1. Loosen bolts (3.81) and remove mounting clamp (3.80).
2. Loosen nuts (3.15) and release the motor wire attach to the
connector kit (3.1)
3. Loosen bolts that link motor (4.52) and transaxle (4.51) up.
4. Loosen screws (4.54) and remove the release lever (4.53).
5. Remove/replace the motor or transaxle.
To Next Page
Loading...
