(2) TO THREAD
(GREEN) (E ON NEEDLE CLAMP)
*
* Pass thread from back to the front through the
thread guide 1.
* Thread the top cover thread guide by pulling the
thread towards the right until it slips under guide.
Then pull thread along the right side of button as
illustrated.
* While holding thread with fingers, pass it between
the tension discs and pull thread down to make
certain it is properly located in between the
tension discs 3.
Thread the right needle as indicated 1~10.
* Raise Presser foot to release Tension discs.
COVER STITCH RIGHT
NEEDLE
17
3
4
5
6
7
8
9
10
1
2
1
2
2
3
3
To Next Page
Loading...
Need help?
General
