* Continue to thread points 4~9.
* Slip the thread into the rear slot on the thread
guide (5) and into the slot on the take-up lever
cover (6). Then slip the thread into the right slot
on the thread guides (7) and (8).
* Before threading the eye of the needle, make sure
thread is in front of thread guide located on the
bottom of the needle clamp (9).
* Thread the eye of the needle. Use the needle
threader (page 21) to make the threading easier.
* Pull about 10 cm (4") of thread through needle
eye to hang free.
* Place the thread to the back, under the presser
foot.
* Thread the cover stitch middle / chain stitch
needle as indicated 1~10.
* Raise Presser foot to release Tension discs.
* Pass thread from back to the front through the
thread guide 1.
* Thread the top cover thread guide by pulling the
thread towards the right until it slips under guide.
Then pull thread along the right side of button as
illustrated.
(3) TO THREAD
THREAD (BLUE)
(D ON NEEDLE CLAMP)
COVER STITCH MIDDLE /
CHAIN STITCH NEEDLE
18
4
5
6
7
8
9
10
5
3
4
5
6
7
8
9
10
1
2
1
2
2
To Next Page
Loading...
Need help?
General
