* To change thread type or color, clip thread near
the spool.
* Place new thread on stand.
* Tie new thread and old thread ends together with
a square knot. Clip thread tails to 2~3cm (1 inch)
length. If clipped too short, threads may come
untied.
* Firmly pull both thread to test knot security.
* Raise Presser foot to release Tension discs.
* Pull the threads through the machine one at a
time.
* If threads do not pull easily, check for tangles on
thread guides or looping under thread stand.
* When pulling thread through the needles,
when the knot is in front of the needle.
* Cut the thread, and insert it through the needle.
STOP
22
15. STITCH LENGTH ADJUSTMENT
14. HOW TO CHANGE THREADS : TIE ON
METHOD
*
The stitch length dial should be set on the
(=2.5) setting for most sewing conditions.
* Adjust the stitch length to (=2.5)~ 5 when sewing
heavy weight fabrics.
* Adjust the stitch length to 2~3 when sewing
lightweight fabrics to obtain excellent seams
without puckering.
1
To Next Page
Loading...
