ES-405-9800 Manual Rev A Page 20
6 SETUP MENU DESCRIPTIONS
The ES-405 has a system of setup menus which contain all of the settings and parameters
needed to perform the measurement and operation of the unit. Many of these settings are set at
factory default values which are correct for most applications but may be altered by the operator to
suit the specific needs of your monitoring program. This section describes the SETUP menu in
detail and should be reviewed to ensure desired operation. Once set, most of the values in the
SETUP menus will not need to be changed by the site operator. The settings will not be lost if the
unit is unplugged or powered down.
The SETUP menu can be accessed through the main ES-405 menu. Use the arrow keys to select
SETUP option in the main menu, then press the MENU key to enter the menu.
Use the ▲▼ keys to select the desired sub-menu and press the ENTER key again to enter. The
top SETUP menu is shown below:
6.1 SAMPLE Setup
Set the Sample Rate and Location ID
The Sample Rate choices are a pick list with the following choices.
SAMPLE RATE: 1 MIN
5 MIN
10 MIN
15 MIN
30 MIN
1 HR
To Next Page