ES-405-9800 Manual Rev A Page 8
2 ES-405 SETUP and STARTUP
The ES-405 is designed for rapid deployment and easy setup by a single person in less than 15
minutes in most applications. This section describes the basic assembly, setup, and start-up of the
instrument.
2.1 Standard and Optional Accessories
When unpacking a new ES-405, verify that the contents are undamaged. If the shipping cartons
are damaged, notify the carrier immediately. Verify that the included accessories are correct and
complete. If anything is missing, contact the technical service department at service@metone.com
or (541) 471-7111. See the Accessories section at the back of this manual for more details. The
normal configuration of the ES-405 is supplied with the following standard accessories:
• Weatherproof TSP inlet with debris screen.
• Instruction manual.
• External power supply and cable.
• USB Cable.
• Mounting brackets.
The following optional accessories may or may not also be included, depending on the order:
• Serial Communications Cable.
• Aluminum Tripod.
• External digital MET sensors.
• External DC power cable for batteries or solar systems.
• Modem Kits for phone line, cell, radio, or satellite telemetry.
• Solar power kits (usually drop-shipped from the solar manufacturer). A DC/DC controller is highly
recommended to regulate incoming voltage to 12V.
2.2 Mounting Options
2.2.1 Basic Unit Mounting
The ES-405 can be mounted using the included mounting ears. The unit must be screwed or
bolted to the support structure with appropriate hardware. For normal wall or pole mounting the
mounting bracket is recommended.
Basic Unit Mounting
To Next Page
Loading...