Metek uSonic-2 - Connection of Power Supply; Connection of Analog Output Signals (Option)

METEK GmbH uSonic-2
13
2.3.3 Connection of power supply
The ultrasonic anemometer uSonic-2 works with an operating voltage of
12...36 VDC. Devices equipped with heated sensor head (option) must be
supported with an operating voltage of 24 VDC.
Consider an adequate power capacity for the power supply, especially for
models with heated sensor head. Look at specification label uSonic-2 and
appendix technical specifications for required max. power.
Note also pin-assignment connector (chapter 2.3.2).
Advise:
Please attend specifications at usage of cables which are not manufactured
by METEK GmbH! Attend local regulations, if required.
2.3.4 Connection of analog output signals (option)
The uSonic-2 provides the possibility to display the measured values by 4
analog output ports.
Following configurations are possible:
2 ports 0..10 V or 0..5 V
and
2 ports 0..20 mA
Note also the correct pin assignment (chapter 2.3.2).
The configuration has to be declared at ordering uSonic-2.
It is possible to configure the analog output signals comprehensively.
Please read chapter 4.
Advise:
Please attend specifications at usage of cables which are not manufactured
by METEK GmbH! Attend local regulations, if required.