METEK GmbH uSonic-2
See chapter 4.2.3.1
VD Version date
Shows the date of creation of the present firmware version.
VN Version number
Shows the present version number of firmware.
VR Velocity Range
Possible setting 1 ... 6000 (cm/s)
To optimize the resolution, the range of the analog output signals can
be configured.
The command VR sets the analog output range for the values
x, y, v and vs.
See chapter 4.2.2
Control commands
AA Abort Averaging Interval
The command AA stops the actual running averaging interval. The
values will be calculated immediately and displayed on the serial
interface. The analog output ports will be refreshed.
To read the data with an external device set the averaging time (AT)
higher than needed and abort the interval with AA.
To Next Page
Loading...