Metek uSonic-2 - RD Redraw Data; RL Read Log; RS Reset; Save Parameters

METEK GmbH uSonic-2
48
R:LU unread dataset storage of the internal data logger
RD Redraw Data
If LD=0
The command RD displays the latest averaged dataset on the serial
interface.
If LD=1
The command RD reads the latest dataset of the internal data logger.
RL Read Log
The command RL reads out the internal data logger. The command RL
displays the oldest, unread dataset of the internal data logger. This
dataset is marked then as read.
If all datasets of the internal data logger are marked as read, a
message “end of log” will appear.
The Read Log command is allowed only if LD is set to 1.
RS Reset
The command RS starts a reset of the uSonic-2. All parameters are
stored in an EPROM, so the uSonic-2 will work after this reset with the
same settings.
S1…
S3 Save parameters
The command L1, L2 and L3 loads the stored configuration.
The command S1, S2 or S3 stores all parameters, including the
calibration parameters, in one of the three internal and independent
storages. (S1 stores to storage #1 etc.)
The stored configuration is named as the N0 command is actual set.