Metek uSonic-2 - BS Battery Status; CA Calibration; Load Parameters; LS Log Status

METEK GmbH uSonic-2 47
BS Battery Status
The command BS reads out the voltage (scaled in V) of the internal
battery. If the voltage is lower than 2,5V, the battery has to be
changed.
Example:
C:BS
R:BV = 3.548
The internal battery buffers the internal data logger and the internal
clock.
CA Calibration
The command CA will calibrate the uSonic-2.
This command is only accepted in the service mode.
See appendix B, calibration procedure!
L1…
L3 Load parameters
The command L1, L2 and L3 loads the stored configuration.
See also description S1…S3
LS Log Status
The command LS reads out the status of the internal data logger.
The uSonic-2 displays the number of free, used and unread storage
spaces.
Example:
C:LS
R:LT total dataset storage of the internal data logger
R:LF free dataset storage of the internal data logger