METEK GmbH uSonic-2 41
LU Logger unread
Shows the number of unread data sets of the internal data logger.
MD Maximum Deviation
Possible setting 0 ... 65535
The command MD defines the acceptance criteria of the internal
quality check.
Example:
MD=0 The internal quality check is switched off.
MD=20 Recommended setting of criteria.
Advice: The command MD should be modified just in case of
necessity. For ex. MD=10 or MD=5, if sensor head has
been de-arranged by mechanical impact. Possibly an
offline correction must be applied on the measured
data. MD=0 should be used only for test purposes.
N0...
N3 Name Parameters
The N0 command names the actual configuration (all parameter,
including the calibration). The actual configuration can be stored
(command S1..S3) and loaded (command L1…L3) with this name.
Maximum number of characters: 31
Example:
N0=20110928 The actual configuration is named 20110928
NO NMEA O ptions
Possible settings 0…31
The command NO defines the output format of the NMEA protocol.
See chapter 5.
To Next Page
Loading...