Meto mn-4 - Page 6

ii
4.5 Calibration Mode .................................................................. 26
4.5.1 Media Sensor Calibration Procedure......................... 27
4.5.2 Auto Media Calibration Procedure............................ 29
4.6 Internal Labels....................................................................... 30
4.6.1 Database Configuration and Dot Check Label .......... 30
4.6.2 Test Label .................................................................. 32
Maintenance and Adjustments
5.0 Introduction........................................................................... 34
5.1 Cleaning the Printhead.......................................................... 35
5.2 Fine Printhead Adjustment.................................................... 36
5.3 Ribbon Width Adjustment .................................................... 37
5.4 Media Width Adjustment...................................................... 38
5.5 Printhead Replacement.......................................................... 39
5.6 Darkness Adjustment ............................................................ 40
5.7 Resetting to the Factory Defaults.......................................... 40
5.8 Downloading Firmware and Fonts........................................ 41
Troubleshooting
6.0 Introduction ............................................................................ 42
Specifications
7.0 Printer Specifications............................................................ 46
Appendix A
ASCII Control Code Chart ............................................................ A-1
Appendix B
Embedded Fonts and Barcodes ..................................................... B-1
Appendix C
Limitation of Liability................................................................... C-1