17.9.2007 Rev. 2.4
Use instructions
4
4. Use instructions
4.1 Before use
4.1.1 Preparations
The ice cube maker has been already cleaned in the factory. However you are advised to
wash the internal parts again before using the appliance.
When you start up the ice cube maker the first time, after service or when you start it up
after a long period of layoff, pour 3 litres of water into the internal basin (see fig.). This
filling operation must be carried out by raising the flaps and pouring the water directly
into the internal basin.
At other times the water runs automatically and the previous procedure is not necessary.
After that, open the water supply tap, insert the plug in the electric supply socket and
switch on the power supply.
Ice cube dispenser DSS:
Turn on the water supply tap and switch on the pover supply.
Remove the plug on the front grid panel. Using a screwdriver turn the adjuster screws of
the timer clockwise (see fig.) until you hear a clik and the water pump stops.
To Next Page
Loading...