17.9.2007 Rev. 2.4
Use instructions
6
To take the require quantity of ice, put a glass or a suitable container under the dispenser
and press the button to turn on the supply. Release the button to stop the ice supply.
4.3 After use
4.3.1 Cleaning
All cleaning operations must be carried out only after the power and water supply have
been disconnected as described previously.
For cleaning operations in general use an ordinary detergent for washing dishes or a solu-
tion of water and 10 % of vinegar. To eliminate sediment, use a soft plastic-bristle brush
and a sponge. You are recommended not to use abrasive detergents or powders, since
these might damage the finishings.
Internal parts cleaning and disinfecting can be carried out only by the authorized technical
service centers.
For air-cooled models, it´s very important to keep the finned condenser clean.
Have the finned condenser cleaned at least once every two months by authorized technical
service center, which can include this operation in the scheduled maintenance program.
4.3.2 Scheduled maintenance
We recommend that you ask your dealer to draw up a scheduled maintenance contract
which will cover the following:
• cleaning of the condenser every two months
• cleaning of the filter located on the water inlet solenoid valve every two months
• check on state of charge of the coolant gas 2 x year
• check of operating cycle 2 x year
• disinfection of the ice cube maker 2 x year.
To Next Page
Loading...