17.9.2007 Rev. 2.4
Installation
9
5.4 Preparing installation
Make sure, that the ice cube maker will be installed on an even surface. Avoid installing
the appliance near heat sources. A floor drain should be found near of the place of instal-
lation. The maximum distance being 5 m. Make sure that the melt water hose presents a
slope of at least 5 % throughout its entire length.
5.5 Unpacking
Remove the cardboard packaging by cutting the straps that hold it in place; then slide it
off from the top.
Once you have removed the packaging, make sure that the ice cube maker is in perfectly
good condition. If you are in any doubt, do not use it and contact immediately the dealer
who sold it to you.
Rest the wooden pallet on the floor and loosen and remove the screws that fix the appli-
ance to the pallet.
5.6 Disposal of packaging
All the packaging items (plastic bags, cardboard, polystyrene foam, nails, etc.) must not
be left within reach of children, in that they are potential sources of danger.
5.7 Installation
Once you have completed the above operations, lift the ice cube maker off the wooden
pallet and screw on the feet supplied in a plastic bag in the ice cube container. Use a spirit
level to check that the appliance is standing perfectly level. If necessary, adjust the feet
(see fig.).
To Next Page
Loading...