17.9.2007 Rev. 2.4
Installation
8
5. Installation
5.1 General
The ice cube maker is delivered attached to a special wooden pallet and protected with
cardboard packaging.
Installation must be carried out exclusively by qualified and authorized staff, in compli-
ance with current national standards and following the manufacturer´s instructions.
5.1.1 Positioning
The best performance of the ice cube maker is achieved at a room temperature of between
10ºC and 35ºC and a water supply temperature of between 3ºC and 25ºC. Consequently,
avoid installing the appliance where it may be exposed to direct sunlight or near to heat
sources, such as radiators, stoves, dish-washers, etc.
This appliance must not be used outside, must not be installed in damp places or where it
is liable to be sprayed with water. The appliance must be positioned at a distance of at least
5 cm from the side walls.
5.2 Possible disturbances from environment (to environment)
If installation is carried out incorrectly, damage and/or injury may ensue to the environ-
ment, persons, animals or things. The manufacturer declines all responsibility for any
such damage or injury.
5.3 Storage
The net weight and the weight including packaging of the ice cube maker are given on the
cover of the packaging. In order to prevent the oil contained in the compressor from flow-
ing into the coolant circuit, make sure to transport, store, and handle the ice cube maker
always keeping it standing upright. Follow the instructions given on the packaging.
The special wooden pallet, built so that it can be lifted with a fork-lift truck, enables the
appliance to be moved around using ordinary means of handling and lifting.
To Next Page
Loading...