Metra Electronics 99-7011 - Kit Preparation; Hazard Switch and AC Vent Integration; Attaching Factory Clips

3
99-7011 KIT PREPARATION
Secure the hazard switch assembly into the radio housing using the factory hard-
ware. Snap the a/c vents into the radio housing. (Figure A)
Use the (7) plastic factory clips previously removed during dash disassembly and
attach where shown. (Figure B)
1
2
PAS
SE
N
GER
PAS
SEN
G
ER
A
IR
B
AG
OF
F
A
REAR VIEW OF RADIO HOUSING
B
MITSUBISHI LANCER 2008-2010
Continue to kit assembly