METREL MD 9225 - Page 16

MD 9225 Clamp Meter Series Specifications
16
Ohms
RANGE
Accuracy
400.0
0.8% + 6d
4.000k, 40.00k, 400.0k
0.6% + 4d
4.000M
1.0% + 4d
40.00M
2.0% + 4d
Open Circuit Voltage : 0.4VDC typical
Audible Continuity Tester
Open Circuit Voltage: 0.4VDC typical
Range: 400.0; Accuracy: 1.5% + 8d
Audible threshold: between 10 and 120.
Diode Tester
Open Circuit Voltage : < 1.6 VDC Typical
Test Current : 0.4mA Typical
Capacitance
RANGE
1)
Accuracy
2) 3)
500.0nF, 5.000F, 50.00F, 500.0F,
3000F
3.5% + 6d
1)
Additional 50.00nF range accuracy is not specified
2)
Accuracies with film capacitor or better
3)
Specified with battery voltage above 2.8V (approximately half full battery). Accuracy
decreases gradually to 12% at low battery warning voltage of approximately 2.4V
DCA Current (Clamp-on)
RANGE
Accuracy
1) 2)
400.0A
0A ~ 50.0A
1.0% + 4d
50.0A ~ 200.0A
1.5% + 5d
200.0A ~ 300.0A
2.0% + 5d
300.0A ~ 400.0A
2.5% + 5d
1)
Induced error from adjacent current-carrying conductor: < 0.01A/A
2)
Relative Zero mode is applied to offset the non-zero residual readings, if any