Metrohm AUTOLAB MULTI M101 - Page 13

Insert a new module for the Multi Autolab Cabinet
Figure 15 – [CORRECT SITUATION] Installation of an optional module into a Multi Autolab Cabinet
Figure 16 – [INCORRECT SITUATION] Optional modules can only be installed in a Daughter position
Figure 17 – [CORRECT SITUATION] Optional modules can only be installed in a Daughter position
Note
Optional modules can only be installed in the Daughter position. This means that each
M101 or M204 module can only control a single optional module. The situation shown
in Figure 16 is therefore not correct. The situation shown in Figure 17 is correct.
13 | Page