Metron, Inc. Date: 03/22/04 Approved: MH DOC#: 586
Revision: P
Date: 03/15/15 Approved: RA Page: 1 of 34
MANUAL FOR MODEL FD4 FIRE PUMP CONTROLLERS
Firmware version 5.02
This manual provides General Information, Installation, Operation, Maintenance and System Set-Up Information for METRON Model
FD-4 Engine Driven Fire Pump Controllers.
TABLE OF CONTENTS
PART I General Information ........................................................................................................................................ PAGE 3
PART II Functions ......................................................................................................................................................... PAGE 3
PART III Operation of the Controller ............................................................................................................................. PAGE 4
PART IV Installation & Test Procedure ......................................................................................................................... PAGE 5
PART V Additional Optional Features ......................................................................................................................... PAGE 9
PART VI Operator Interface Device (OID) Use and Navigation ........................................................................ PAGE 10
PART VII System Set Point Definitions ........................................................................................................................ PAGE 18
PART VIII Alarm and Event Log Messages ................................................................................................................... PAGE 22
PART IX SD Card File Format .................................................................................................................................... PAGE 25
Appendix A Modbus Protocol ........................................................................................................................................... PAGE 29
METRON, INC.
Hubbell Industrial Controls Inc.
4301 Cheyenne Drive, Archdale, NC 27263
www.metroninc.com
Telephone: (336) 434-2800 Ext. 183
To Next Page
Need help?
General
