Waveforms
The oscillators’ waveforms are continuously blended using the WAVE
controls. The succession of the waveforms is: Sub > Saw > Triangle >
Square > Extra.
SUB is a square-sub-oscillator which plays an octave below the
selected register. The EXTRA waveform can be selected from the
VCO-menus.
VCO - modulation sources
MENU VCO1/2/3 are used to select the modulation sources for the
parameters PITCH and WAVE as well as for the EXTRA waveform.
Mod Pitch: LFO1, LFO2, Env1, Env2, Env3, AftT
Mod Wave: LFO1, LFO2, Env1, Env2, Env3, Velo
Extra: Pulse, Ring (VCO1 * VCO2) / Pulse, Noise (for VCO3)
Modulation
The modulation sources being selected for pitch and waveform in
the VCO-menus are adjusted in their intensity using the MOD PITCH
and MOD WAVE controls.
The overall pitch of SYNTH PRO can be controlled using the pitch
wheel of a MIDI-keyboard or the corresponding MIDI control
command.
The range of the pitch-wheel can be adjusted in the MENU
Additional.
Pitchbend: 02, 04, 07, 12 (VCOs), 12 (VCO2, VCO3)
Glide
Glide (Portamento) is set by MISC button 4. With the LED above the
button being lit, the glide-time can be adjusted between 00-31 using
the VALUE control. Accordingly, press MISC button 4 again (LED turns
off).
Via the MENU Additional, the glide curve be set to either linear (Lin)
or logarithmic (Log).
To Next Page
Loading...
