ENVELOPES
SYNTH PRO offers three ADSR-envelopes with loop-functions. The
envelopes can be assigned to any targets. Typically, ENV 1 controls
the VCA level while ENV 2 is routed to control one or both filters in
most presets.
For ENV 1 and ENV 2, the parameters ATTACK, DECAY, SUSTAIN and
RELEASE are adjusted by dedicated controls. With LOOP being
enabled (LED lit red), the ATTACK and DECAY phases are looped
which basically turns the envelope into a LFO. The values of both
controls adjust the course and the speed of the cycle.
Hint: When using a sustain pedal, the release times of ENV 1 and ENV
2 will temporarily be set to their maximum values.
For ENV 3, decay and release are adjusted commonly using the
DEC/REL control. The sustain level can be adjusted from 00-31 via the
MENU Additional.
Hint: Only one of the three envelopes can be run in loop-mode at a
time.
LFOs
LFO1 and LFO2 offer identical features. The RATE controls specifies
the speed within a range of approx. 50 seconds and 200 Hz. The
WAVE control selects the waveform. This control offers a continuous
blend between descending sawtooth, triangle and ascending
sawtooth. Afterwards, the control switches to a square and then to a
sample & hold setting.
To Next Page
Loading...
