Need help?Do you have a question about the MFJ MFJ-941EK and is the answer not in the manual?
Use the bill of material (BOM) on the next page to account for all the pieces in your kit, checking each part off as you go.
Find the circuit board and take a minute to survey the component-side legend for various part locations.
Find the MFJ-941E chassis. Also, find the following hardware items: (3) 4-40 x 1/2" Machine Screw...
These procedures require the following items: (1) 100-Watt HF transceiver with adjustable RF-power output...
To begin calibration, tune your radio to 14.200 MHz and select a mode that will deliver the radio's full rated CW output.
The T-network is a highly flexible tool for matching a wide range of loads into 50 Ohms.
MFJ-941EK Schematic Diagram:
To Next Page
General
