To Next PageTo Next Page
Need help?Do you have a question about the MFJ MFJ-998 and is the answer not in the manual?
General| Type | Automatic Antenna Tuner |
|---|---|
| Frequency Range | 1.8 - 30 MHz |
| Input Impedance | 50 Ohms |
| Output Impedance | 50 Ohms |
| SWR Range | 1:1 to 3:1 |
| Power Handling | 1500 Watts PEP |
| Tuning Time | Typically less than 2 seconds |
| Antenna Impedance | 16 to 150 Ohms |
| Tuning Technology | Microprocessor controlled |
| Metering | SWR / Power |
| Display | LCD |
| Power Requirements | 13.8 VDC |
Lists key features like 1500W handling, 20,000 memories, and Amplifier Bypass Control.
Details technical specs including impedance, power, frequency range, and connectors.
Explains the Amplifier Bypass Control for protecting amplifiers during tuning.
Provides a step-by-step guide for initial setup and operation of the tuner.
Overview of the tuner's front panel interface and controls.
Describes the cross-needle meter for measuring forward, reflected power, and SWR.
Details operation of TUNE, StickyTune, Auto/Semi modes, and POWER button.
Describes connectors on the rear panel like Amp Enable, Power, Serial Port, and Antenna connectors.
Explains the RJ-45 connector for radio control and compatible radios.
Guides users through customizing tuner settings like Target SWR and Meter Range.
Selects the radio interface type for communication with the tuner.
Explains how to manually adjust inductance and capacitance for tuning.
Details procedures for factory defaults, total reset, and deleting memory.
Lists the default settings for various tuner parameters.
Step-by-step guide to calibrate the analog SWR/Wattmeter.
Instructions for calibrating the internal SWR bridge.
