MGE UPS Systems 2000 - Page 16

Page 16 - 51033211EN/AC
2. Installation
2.5 Securing and connecting the connection modules
1. Insert the connection module in the connector .
2. Secure the connection module to the UPS using
the two screws .
Connection to the AC-power source:
1. Connect the electrical power cord to the socket
for connection to AC-power source.
2. Connect the other end of the electrical power cord
to an AC-power outlet.
Fault tolerant
29
1
Securing the connection modules
Connection of equipment:
Connect the protected equipment directly to the outlets
2 .
Before carrying out any connections, check that the battery circuit breaker is OFF and that the
electrical power cord to the AC-power source is disconnected.
10
31
8
10
31
31
2
1
29