Need help?Do you have a question about the MGE UPS Systems 2000 and is the answer not in the manual?
General| Brand | MGE UPS Systems |
|---|---|
| Model | 2000 |
| Category | UPS |
| Language | English |
Introduction to the Pulsar EXtreme range, covering both Tower and Rack models with their basic specifications.
Explanation of the LED indicators for alarms (overload, fault, battery, temp) and their meanings.
Description of the functions associated with the control panel buttons, such as lamp test and power ON/OFF.
Describes the normal operating mode of the UPS, explaining LED indicators for AC power availability.
Step-by-step guide for initial UPS startup, including checks and button operations.
Explanation of what to do if UPS LEDs flash, indicating a fault or anomaly.
Details the UPS behavior when AC input power fails or goes out of tolerance, including LED and buzzer alerts.
Explains the low battery warning threshold, LED flashing, and buzzer alerts before automatic shutdown.
Guide on installing and using the UPS Driver software for personalizing UPS parameters.
Steps to safely shut down equipment connected to the UPS while maintaining battery charge.
Procedure for completely powering off the UPS, including disconnecting AC power and opening the circuit breaker.
Guidance for resolving common UPS issues indicated by LED flashes or buzzer beeps without needing after-sales support.
Detailed explanation of specific LED indications (14, 15, 16, 17, 20) and their corresponding fault significations.
Identification of UPS faults (LED 15 flashes) that require assistance from MGE after-sales support.
Step-by-step instructions for disconnecting and reconnecting the fault-tolerant connection module.
Procedure for safely disconnecting the UPS and connection module for hot-swap or install types.
Procedure for reconnecting the UPS and connection module, verifying settings and operation.
To Next Page