Mi MJSTG1 - How to Use; Setup and Initial Charging

09
How To Use
1. Before use
3. Place the charging dock on the level ground
against a wall.
2. Connect to the power supply
4. Turn on and charge the vacuum-mop. Press
and hold the buon " " for 3 seconds to turn
on the vacuum-mop. When the indicator lights
up, manually place the vacuum-mop onto the
charging dock to charge.
0.5m
1.5m
0.5m
Open the boom cover of the charging dock. Connect the power
cord, and wrap any excess cord around the spool on the boom
of the dock, then remove the protective film from the IR sensor.
Remove the protective foam strips from both sides, and peel
the protective film off the collision sensor.