Mi MJSTG1 - Care and Maintenance; Cleaning Schedule and Part Replacement

Care & Maintenance
Recommended Cleaning & Part Replacement Schedule
Note: Turn off the vacuum-mop and disconnect it from the power supply before performing cleaning or maintenance.
Actual part replacement cycle may vary depending on usage conditions.
Component
2-in-1 Dust Compartment with Water Tank
Filter
Brush
Side Brush
Cleaning Brush
Brush Cover
Cliff Sensors
Charging Contacts
Caster Wheel
Mop Assembly
Mop Pad
Cleaning Frequency
Aer each use
Once a week
Once a week
Once a month
Aer each use
Once a month
Once a month
Once a month
Once a month
Aer each use
Aer each use
Recommended Replacement Cycle
Replace if worn or damaged
Every 6 months (or every 150 working hours)
Every 6 to 12 months (or every 300 working hours)
Every 3 to 6 months (or every 150 working hours)
Replace if worn or damaged
Replace if the brush cover's silicone rubber strip becomes noticeably worn
No replacement necessary
No replacement necessary
Replace if worn or damaged
Replace if worn or damaged
Every 3 to 6 months (or upon noticeable wear)
14