Using Automatic Link Establishment (ALE)
57
Quick Call
A quick call is a call to the last station you tried to call (regardless of whether the call was successful or
not). In the ALE mode, the channel used for the original call is reused for the quick call.
The Quick Call feature can be enabled or disabled as part of ALE parameters programming.
Notes
• Quick Call will not transmit a message, even if the last call contained a
message.
• The first time the station is switched to the ALE or Channel mode, quick call is
not possible as no "most recent" station data exists.
➤ To send a quick call:
Double-press the PTT of your microphone or handset.
The radio automatically tries to contact the last called station.
During this process, you will see TO alternating with the number of
the channel on which the set up request is being sent (the channel
may change, if the called station does not answer on the first
channel(s)).
Note
While the radio is initializing the link, you can press
STOP (F1) or ESC to abort the entire process.
MICOM-3
STOP
TO
1234
MICOM-3
STOP
CH 2
1234
To Next Page
Loading...
