MICOM-3F/3T/3R HF-SSB Owner’s Guide
58
Using Autodial
The Autodial feature lets you use a single digit to call a preprogrammed address. There are ten
programmable Autodial addresses, where each can include a message.
See Auto Dial Parameters on page 93 for details on programming the Autodial list.
➤ To use Autodial to send a call:
1. Press # on the keypad.
MICOM-3
CALL
SELECT#_
Note
If you do not select an auto-address within a few seconds, the display
automatically reverts to the previous state.
2. Press the desired preprogrammed Autodial number (0 to 9).
The programmed address is immediately displayed; if a
message is preprogrammed, an exclamation sign will appear
before the station name.
Press PAGE (F2) if you want to attach a message to the call or
to replace/edit a preprogrammed attached message.
See page 59.
MICOM-3
SEND
PAGE
MON
CALL
1009
I
Note
If the Autodial number you enter is not programmed, the message NOT PROG
will be displayed.
3. Press CHAN (F3) if you want the call to be initiated on a specific channel. See page 59.
4. Press ENTER or SEND (F1) to start the call.
5. The radio now starts the link set up process. During this process, you will see TO
alternating with the number of the channel on which the set up request is being sent (the
channel may change, if the called station does not answer on the first channel(s)).
Note
While the radio is initializing the link, you can press STOP (F1) or ESC to abort the
entire process.
6. After the link is established, you will see a LINK message. Now you may press the PTT and
start talking.
7. To disconnect the link, press the ESC key (see page 48).
To Next Page
Loading...
