Micom 3R - DIR

MICOM-3F/3T/3R HF-SSB Owner’s Guide
72
5. Press WILD (F1) to start.
MICOM-3
SEND
PAGE
CHAN
SEL
CALL
WILD
6. Press SEL (F4).
MICOM-3
?
WILD
_
Note
If you try to send (SEND (F1)) the call without first selecting an address, your
attempt is rejected and you see for a few seconds NOT PROG.
7. Select the desired address:
• To insert a wildcard, press ? (F1).
• Enter the desired characters using the keypad
MICOM-3
?
<--
-->
CLR
WILD
?135?
8. Confirm your selection by pressing ENTER.
MICOM-3
SEND
PAGE
CHAN
SEL
CALL
?135?
9. Press PAGE (F2) if you want to attach a message to the call.
10. Press CHAN (F3) if you want to initiate the call on a specific channel.
11. Press SEND (F1) or ENTER to initiate the call.
Note
If the selected group does not include at least 2 stations, your request is rejected
and you will see for a few seconds AT LEAST 2.
The radio now starts the process. During this process, you will see TO alternating with the
number of the channel on which the request is being sent.
Note
You can press STOP (F1) or ESC to abort the entire process.
12. After a delay, you will see LINK with the wildcard address
flashing.
MICOM-3
PAGE
LQA
MON
LINK
?135?
I
13. Confirm the link set up by pressing ENTER or the PTT. The
address stops flashing, and you can start talking.
MICOM-3
PAGE
LQA
MON
LINK
?135?
I