Micro-Air, Inc. Page 4 EasyTouch Operations Manual
Rev 3.0 4/3/17
1. INTRODUCTION
The EasyTouch Control is a microcontroller-based unit designed for use with direct expansion, reverse-
cycle air conditioning systems or with chilled-water air handlers.
2. READ THIS MANUAL BEFORE PROCEEDING
Read this manual completely before you proceed with the installation and operation of the EasyTouch. If
you have questions or require assistance with your EasyTouch control, contact Micro-Air at +1 (609) 259-
2636.
The EasyTouch is covered under the Micro-Air Warranty Policy, and incorrect installation, neglect and
system abuse are not covered under warranty policy. See section 19 for more details.
3. FEATURES
3.1 Standard
Works automatically via auto-detection with FX1 or FX2 control circuit boards.
User-friendly and intuitive 2.5” touch screen display requires no manual for basic operation.
Five-volt logic and microcontroller located in the display.
Automatic and three programmable manual fan speeds.
Numerous programmable parameters for custom installations.
Moisture Mode for controlling relative humidity.
De-Icing cycle to prevent evaporator coil icing.
Programmable compressor staging delays.
Universal 115-230V, 50/60Hz AC power supply.
Nonvolatile memory retains settings without batteries.
Programmable display-brightness control.
Programmable failsafe modes.
Integrated CAN-bus network capability
Low-Voltage Monitor.
AC Current Monitor
Fits Vimar® Eikon and Eikon EVO bezels.
3.2 Optional
Outside air temperature sensor.
Alternate air temperature sensor.
Pump Sentry (Service) water sensor.
Combination Temp/%RH sensor for Cabin Relative Humidity Control in CW
Electric heating control capabilities in reverse-cycle DX and in CW.
Air Filter Cleaning or Replacement Timer.
Fresh Air Makeup (FAMU) DX and CW Control
Expanded 4x DC Blower Output (daughterboard) support
EasyStart Soft Starter (daughterboard) support
Wi-Fi support for EasyTouch smart phone application
To Next Page
Loading...
