6.2 ILR11xx
Once the device has been connected to the power supply the display shows the measured value if a target or
a reflector is in the path of the beam. The green POWER LED lights up. The sensor needs a warm-up time of
about 15 min for repeatable measurements.
6.2.1 Control and Display Elements
Key Description The ILR11xx sensors are equipped
with an LCD display and 3 keys
which control all instrument func-
tions.
ESC
Display
Fig. 19 Front view - Display
- Select function, switch down one menu level
- Save value, switch up one menu level
- In operating mode: Switch to menu level (If pass-
word function is active, changes to password entry.
Measuring mode remains active until correct pass-
word has been entered.)
- When editing e.g. switching points: Switches cursor
position from right to left or stops entry if cursor is at
the far left.
- Scrolls to the next function (right)
- Editing: Increase current digit by 1
- In QuickSet menu it enables the teach-in of Q2,
- In measuring mode: Press this key to light up the
display.
- Scrolls to the next function (left)
- Editing: Decrease current digit by 1
- In QuickSet menu it enables the teach-in of Q1
- In measuring mode: Press this key to light up the
display.
Cancels active function and switches to next menu level above (important: keys must be pressed
simultaneously, previous value is maintained unaltered)
To Next Page
Loading...
