6.2.4 QuickSet
ESC
4564
Q1 III q2
Example: QuickSet
current value:
4564,
Q1 = ON,
Q2 = OFF,
Incoming energy:
ca. 50 %
The current measured value is displayed in the first line. In the center of the second
line the energy value is displayed as an alignment aid in the form of a bar graph.
Q1 and Q2 can be taught directly by pressing the appropriate button (the teach-in
function is not possible if SSI mode is active).
Depending on the selected mode of the switching outputs (see teach-in menu),
see Chap. 6.2.5,
- the rising or falling edge of the switching output is taught with the set hysteresis
in Single switching mode.
- In Double switching mode the teach-in point (LP) marks the center of the
switching points (rising or falling edge). The switching points are located sym-
metrically in a distance of 100 mm around LP with the set hysteresis.
Meaning of the display symbols:
Q1 = Output 1 ON
q1 = Output 1 OFF
Q2 = Output 2 ON
q2 = Output 2 OFF
The appropriate LEDs (yellow) on the front of the
sensor indicate the state of the switching points
also. Quit the menu with the Enter key or the
ESC function.
ILR
Hysteresis
±100 mm
Target
LP
no hysteresis
with hysteresis
Mode
Mode
Q1
Q1
Fig. 23 Switching points in the Double switching mode, with and without hysteresis
To Next Page
Loading...
