MICRO-EPSILON optoNCDT ILR 102 series - 3 Functional Principle, Technical Data; Sensor Models

Page 9
Functional Principle, Technical Data
optoNCDT ILR 102x/110x/115x
3. Functional Principle, Technical Data
3.1 Sensor Models
The sensors of the series ILR102x/110x/115x use
the principle of pulsed light runtime measurement.
The sensors measure the distance to a tar-
get (ILR1020/1100/1150) or a reflector
(ILR1021/1101/1151). The distance measuring
is done with an infrared laser. An additional red
target laser is used for mounting and adjustment
purposes.
The measurements are provided with analog or
digital standard interfaces.
Fig. 2 Front view
ILR1020/1021
Fig. 3 Front view
ILR110x/115x
The series ILR102x sensors contain:
- 2 buttons for complete on-site setup
- Analog output, 4 .. 20 mA
- 2 switching outputs
The series ILR11xx sensors contain:
- LCD display and 3 buttons for complete on-site
setup
- RS422 interface
- SSI compatible interface (GRAY or BIN)
- 2 switching outputs, error and plausibility
output
- Bus communication with external bus adapter
- Analog output, 4 .. 20 mA, (only ILR11x0)
Fig. 4 Rear view
ILR1020/1021
Fig. 5 Rear view
ILR110x/115x