MANUAL.LM20 Revision C January 2023 Page 12 of 52
Optional Features:
15. Cooling Bath: Includes cooling coil. Allows product to be cooled after processing.
16. Product Outlet: Post-processed material exits the system here when using the cooling bath option
17. Cooling Bath Drain: Spigot drain for cooling bath cooling fluid.
Chapter 3: Operation
3.1 Safety Warnings & Cautions
! "WARNING" indicates that if a specific procedure or practice is not followed correctly, bodily injury
could occur.
! "CAUTION" indicates that if a specific procedure or practice is not observed, damage to the equipment
could result.
The Microfluidizer
TM
Processor you have purchased, rented or leased is carefully engineered and tested.
Using it involves the handling of fluids at high pressure. Therefore, certain precautions must be taken. DO
NOT proceed with this chapter until you read and understand the introduction and have completed the
necessary installation requirements. Refer to chapter 2 "Overview", to identify individual parts.
! WARNING: NEVER TIGHTEN FITTINGS OR ADJUST THE MICROFLUIDIZER
TM
EQUIPMENT WHILE IT IS
UNDER PRESSURE OR WHEN IT IS RUNNING.
! WARNING: DO NOT USE DAMAGED MICROFLUIDIZER
TM
PPROCESSOR EQUIPMENT OR EQUIPMENT
THOUGHT TO BE DAMAGED. ALWAYS USE MICROFLUIDICS GENUINE PARTS.
!
WARNING: DO NOT RESTRICT OR DEAD-END PIPING AFTER THE INTERACTION CHAMBER. BODILY
INJURY COULD OCCUR.
!
WARNING: USE PROPER PERSONAL PROTECTION DEVICES WHILE OPERATING THE MICROFLUIDIZER
TM
PROCESSOR. ALWAYS WEAR SAFETY GLASSES.
! CAUTION: Do not attempt to lift the Microfluidizer
TM
equipment by any of the mounted components.
Serious personal injury and/or damage to the equipment could result. The Microfluidizer™ Processor
weighs approximately 230 LBS (104KG).
To Next Page
Loading...