microHAM © 2010 All rights reserved
CW MESSAGES TAB
On this tab you can define nine CW messages of up to 50 characters each which are stored in EEPROM.
Each memory may have a programmable repeat delay and/or call another memory.
Commands which may be included in a memory are:
Merge: merge two characters without a letter space – [M]AS will sound AS .-...
Cancel WPM: restore speed set by the Speed pot.
Set WPM: force speed to the selected value regardless of position of speed knob.
Set Key: close CW output for selected time in seconds.
Set Wait: wait selected seconds during playback.
Jump to: used for looping a message or calling another message
Delay: sets the delay in seconds before looping or calling another message
Test: plays a message without storing it
Store: saves one message to microKEYER II memory
Store All: saves all messages to microKEYER II memory
Load from File: loads all messages from file
Save to File: saves all messages to file
Messages can also be saved and replayed using an external keyboard or numeric keypad attached to the
PS/2 jack. See: External Keyboard.
NOTE: Messages are not saved or loaded with Presets
39
To Next Page
Loading...
Need help?
General
